Search Criteria
Products meeting the search criteria
If you want to make a robot which has lots of moving parts or if you want to control too many LEDs with PWM outputs, then the limited PWM outputs of your microcontroller would be a big problem for you. To overcome this problem, the only thing you should do is to get a 16-Channel 12-Bit PWM/Ser..
₹299.00
Ex GST: ₹253.39
The MPR121 is a capacitive touch sensor controller driven by an I2C interface. The chip can control up to twelve individual electrodes, as well as a simulated thirteenth electrode. The MPR121 also features eight LED driving pins. When these pins are not configured as electrodes, they may be used to ..
₹199.00
Ex GST: ₹168.64
This is XH-W1219 12V Digital Display Temperature Controller Module with NTC Waterproof Temperature Sensor. The XH-W1219 thermostat module with its STM8S µC and I/O (sensor input, keys, double display, relay) can be re-programmed for automation tasks, and it’s easy to work with.Digital thermostat mod..
₹289.01
Ex GST: ₹244.92
2000W 220V SCR Voltage Regulator Dimmers Speed Controller Thermostat is a speed controller used to control AC supply and suitable for electric furnace, water heater, lamps, small motor, electric iron. etc. You can play a brightness adjustment, speed, pressure, temperature control effect, v..
₹199.00
Ex GST: ₹168.64
Motor:Specifications:Model NO.: A2212Dimension: 27.8*27mmShaft diameter: 3.17mmMax Efficiency: 80%Max Efficiency Current: 4-10A (>75%)Current Capacity: 12A/60sNo Load Current @ 10V: 0.5ANo. Of Cells: 2-3 Li-PolyWeight: 65gKV: 1000Suitable for the propeller size: 1045, 1047,1060, 9050ESC:Des..
₹759.00
Ex GST: ₹643.22
Motor:SPECIFICATIONS:Model NO.: A2212Dimension: 27.8*27mmShaft diameter: 3.17mmMax Efficiency: 80%Max Efficiency Current: 4-10A (>75%)Current Capacity: 12A/60sNo Load Current @ 10V: 0.5ANo. Of Cells: 2-3 Li-PolyWeight: 65gKV: 1000Suitable for the propeller size: 1045, 1047,1060, 9050ESC:DES..
₹779.00
Ex GST: ₹660.17
This is the new APM 2.8 autopilot module. The sensors are exactly the same as with APM2.6, this version is ideal for use with multi-copters and rovers. The APM 2.8 is a complete open source autopilot system and the bestselling technology that on the prestigious 2012 Outback Challenge UAV competition..
₹6,999.00
Ex GST: ₹5,931.36
The KK2.1.5 is next big evolution of the first generation KK flight control boards. The KK2.1.5 was engineered from the ground up to bring multi-rotor flight to everyone, not just the experts. The LCD screen and built in software makes install and setup easier than ever. A host of multi-rotor craft ..
₹5,999.00
Ex GST: ₹5,083.90
CC3D EVO CopterControl Hardware FeaturesPowerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.3-axis high-performance MEMs gyros and 3-axis high-performance&n..
₹1,199.00
Ex GST: ₹1,016.10
DJI NAZA-M V2 Multirotor Autopilot Controller set With GPS Supports nine multi-rotor configurations, the DJI NAZA-M V2 Multirotor Autopilot Controller set With GPS acts as the brains of the aircraft, managing pilot input and interpreting data from the various sensors, helping maintain a stable flyin..
₹22,499.00
Ex GST: ₹19,066.95
The DJI NAZA-M Lite V1.1 with GPS Kit is a simplified version of, and it inherits the high reliability and stability from the Naza M flight controller’s heritage. The Naza M Lite controller has an all-in-one design that means the installation is easy and straightforward while saving space and weight..
₹15,269.00
Ex GST: ₹12,939.83
Characteristics:Compatible with Alexmos2.2 or firmware below, compatible with the newest firmware BruGi_050 German, standard Russian2.2 firmwareTipsA new generation of strong input control 32-bit processor, a circuit board with PX4FMU + PX4IOSpecifications:32-bit Pixhawk PX4 Autopilot Open Code Fli..
₹14,960.00
Ex GST: ₹12,677.97
This PIXHAWK 2.4.8 Full Combo Kit consists of all in one required product for the drone flight controller. find all product included in this kit at below package includes.PIXHAWK PX4 2.4.8 Flight Controller is a high-performance autopilot-on-module suitable for fixed-wing, multi-rotors, helicopters,..
₹14,960.00
Ex GST: ₹12,677.97
The RAMPS (RepRap Arduino Mega Shield) is an all-in-one design to fit the necessary components for a 3D printer into one plug in shield for an Arduino MEGA. The plug in shield design includes plug in stepper drivers and extruder control electronics sockets for easy service, part replacement, upgrade..
₹549.00
Ex GST: ₹465.25
The TB6560 Driver Board 3A CNC Router Single 1 Axis Controller Stepper Motor driver board is for axis control with Input signal high-speed optocoupler isolation, the large heat sink to ensure good heat dissipation. Stepper motor driver is Semi-flow mode adjustable, semi-flow current adjustable, with..
₹449.00
Ex GST: ₹380.51
7805 is a voltage regulator integrated circuit. It is a member of 78xx series of fixed linear voltage regulator ICs. The voltage source in a circuit may have fluctuations and would not give the fixed voltage output. The voltage regulator IC maintains the output voltage at a constant value. The xx in..
₹10.62
Ex GST: ₹9.00
AT89C51 is an 8-bit microcontroller and belongs to Atmel's 8051 families. ATMEL 89C51 has 4KB of Flash programmable and erasable read only memory (PEROM) and 128 bytes of RAM. It can be erased and program to a maximum of 1000 times. In 40 pin AT89C51, there are four ports designated as P1, P2, P3, a..
₹107.00
Ex GST: ₹90.68
Atmega32 microcontroller is a type of low-power 8-bit CMOS microcontroller. The architecture of this microcontroller is based on enhanced RISC architecture. ATmega achieves throughputs of 1 MIPS/MHz by executing powerful instruction, which allows the designer to optimize power consumption and speed...
₹219.00
Ex GST: ₹185.59
The ATMEGA328P-PU is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega328P-PU achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus pro..
₹145.00
Ex GST: ₹122.88
The ATMEGA8A-AU is an 8-bit high-performance low-power AVR RISC-based Microcontroller combines 8kB ISP flash memory with read-while-write capabilities, 512B EEPROM, 1kB SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible timer/counters with compare modes, interna..
₹99.00
Ex GST: ₹83.90
The high-performance, low-cost CP21xx USB to UART bridge family offers a complete plug and play interface solution that includes royalty-free driver suites and a comprehensive design ecosystem that enables customers to speed time-to-market. The crystal-less operation, in-system programming memory, a..
₹99.00
Ex GST: ₹83.90
Specifications40-pin Low Power MicrocontrollerFlash Program Memory: 8192 bytesEEPROM Data Memory: 256 bytesSRAM Data Memory: 368 bytesI/O Pins: 33Timers: Two 8-bit / One 16-bitA/D Converter: 10-bit Eight ChannelPWM: Two 10-bit ModulesSSP: SPI and I²C SupportUSART: YesExternal Oscillator: up to 20MHz..
₹149.00
Ex GST: ₹126.27
The PIC24FJ64GB002-I/SP is a 28-pin general-purpose Flash Microcontroller with USB On-The-Go (OTG) and nanoWatt XLP technology. The 16-bit low power microcontroller with full-speed USB, 64kB flash memory, 8kB RAM and advanced peripherals. The USB On-The-Go module provides on-chip functionality as a ..
₹249.00
Ex GST: ₹211.02
The Zumo robot for Arduino is an Arduino-controllable tracked robot platform that is less than 10 cm × 10 cm—small enough to qualify for Mini Sumo. It includes two micro metal gearmotors coupled to a pair of silicone tracks, a stainless steel bulldozer-style blade, an array of six infrared reflectan..
₹11,994.00
Ex GST: ₹10,164.41
-2 %
This Hexacopter combo kit includes almost all parts for the basic Hexacopter drone. It includes everything to make and fly your own Hexacopter. The flight controller comes with this drone is APM 2.8 which is a very popular and stable flight controller. Package Include:1 x Ardupilot APM 2.8 Flig..
₹14,999.00 ₹15,299.00
Ex GST: ₹12,711.02
For entry-level enthusiasts, now brings out the most cost-effective solution, the DJI Naza-M Lite Multi-Rotor Flight Controller system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M. The innovative All-in-one design simplifies installation and sa..
₹6,199.00
Ex GST: ₹5,253.39
Showing 1 to 26 of 26 (1 Pages)